Plug the ribbon cable from the handheld controller into the OFFLINE port. Note: Disconnect the USB cable from your computer when using the offline controller. 4. Initial Software Configuration

Assuming you have found your PDF, here is the standard setup procedure:

$100, $101, $102: Steps per mm for X, Y, and Z. If your cuts are the wrong size, these need calibration.

Highly stable and widely compatible with engraving software.

Annoy Tools Cnc Board Manual Pdf [new] < Linux >

Plug the ribbon cable from the handheld controller into the OFFLINE port. Note: Disconnect the USB cable from your computer when using the offline controller. 4. Initial Software Configuration

Assuming you have found your PDF, here is the standard setup procedure: annoy tools cnc board manual pdf

$100, $101, $102: Steps per mm for X, Y, and Z. If your cuts are the wrong size, these need calibration. Plug the ribbon cable from the handheld controller

Highly stable and widely compatible with engraving software. $102: Steps per mm for X

Follow our WhatsApp Channel

Click Here
X