Palfingercranemanualerrorcodes: |best|

: The ability to download an error history helps identify intermittent "ghost" issues that only happen under specific loads. The Challenges

Repair the sensor, wiring, or clear the overload. Press MLX: Press the MLX button on the console. palfingercranemanualerrorcodes

| Code | Cause | Elimination | | :--- | :--- | :--- | | | The boom has been luffed up (raised) too far, falling below the minimum radius or exceeding the maximum angle allowed in the load chart. | Luff the boom down into a radius or angle listed in the load chart. | | E02 | The boom has been luffed down (lowered) too far, exceeding the maximum radius or falling below the minimum angle allowed. | Luff the boom up into a radius or angle listed in the load chart. | | E03 | The boom position is outside the permissible working area (e.g., slewed over the front of the truck). | Move or slew the boom back to the permitted working area. | | E04 | The operating mode switch in the console is incorrectly set, or the selected mode is not permissible for the current crane configuration. | Correctly set the operating mode to the code assigned to the crane's configuration. | | E05 | The boom is telescoped too far or not far enough for the permitted working range. | Extend or retract the boom to the correct length, as specified in the load capacity chart. | | E18 / E83 | These are less common codes related to sensor or specific geometry monitoring errors and may require service intervention. | Consult the service manual for advanced troubleshooting. | : The ability to download an error history